Configuring the Netopia 3546 router for Bridge Mode:
1. Browse into the Cayman router’s web interface.(192.168.1.254)
2. Click on Home.
3. Click on the configure tab in the upper menu bar.
4. Click on the LAN link in the menu selections.
5. Click on DHCP Server.
6.
Set
Server
Mode to OFF.
7.
Click
Submit
8. Click on the Advanced link.
9.
Click on
the
10. Under the heading Ethernet Bridge, check the Enable Bridging Function selection and make sure the Enable WAN - to - WAN Bridging is unchecked.
11. Under Ethernet 100BT (LAN) check Enable Bridging on Port
12. Under PPP over Ethernet vcc1 (WAN) check Enable Bridging on Port and make sure Filter PPPoE Only is unchecked.
13. Click on Submit.
14. Click on the WAN link.
15. Click on ATM
16. Set the VCI accordingly UE=33 Paradyne=35
17. Click on Submit
18. Click on the WAN link
19. Click on PPP over Ethernet vcc1.
20. “Uncheck” the Enable Interface box.
21. Click on Submit.
22. Click on the WAN link.
23. In the box labeled IP Gateway, uncheck the Enable Gateway Option
24. Click on Submit.
25. Click on the little yellow alert symbol in the upper right of the menu box.
26. Click on Save
27. Confirm that the configuration database has been updated by looking in the lower left corner of the display.
28. Click the Restart button beside the Help button in the upper right of the menu box.
29. Click on the link to Restart the Device
30. Click on Restart the Gateway. The modem will now proceed to restart and permanently save the settings.